Cisco ONS 15454 Series - DLP- A196 Delete a BLSR from a Single Node

18-68
Cisco ONS 15454 Procedure Guide, R5.0
March 2007
Chapter 18 DLPs A100 to A199
DLP-A196 Delete a BLSR from a Single Node
Step 6 Return to your originating procedure (NTP).
DLP-A196 Delete a BLSR from a Single Node
Step 1 In node view, display the node that was removed from the BLSR:
• If the node that was removed is connected to the same LAN as your computer, from the File menu,
choose Add Node, then enter the node name or IP address.
• If the node that was removed is not connected to the same LAN as your computer, you must connect
to the node using a direct connection. See Chapter 3, “Connect the PC and Log into the GUI” for
procedures.
Step 2 Click the Provisioning > BLSR tabs.
Step 3 Highlight the ring and click Delete.
Step 4 In the Suggestion dialog box, click OK.
Step 5 In the confirmation message, confirm that this is the ring you want to delete. If so, click Ye s.
Step 6 Return to your originating procedure (NTP).
DLP-A197 Initiate a Path Protection Force Switch
Caution The Force Switch Away command overrides normal protective switching mechanisms. Applying this
command incorrectly can cause traffic outages.
Caution Traffic is not protected during a Force protection switch.
Purpose This task deletes a BLSR from a node after you remove the node from the
BLSR.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task switches all circuits on a path protection span to another span.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Maintenance or higher