Cisco ONS 15454 Series User Manual

22-12
Cisco ONS 15454 Procedure Guide, R5.0
October 2005
Chapter 22 DLPs A500 to A599
DLP-A519 Apply Alarm Profiles to Ports
Figure 22-4 Store Profiles Dialog Box
Step 17
Click OK to store the profile.
Note Click the Hide Identical Rows check box to configure the Alarm Profiles window to view rows
with dissimilar severities.
Note Click the Hide Reference Values check box to configure the Alarm Profiles window to view
severities that do not match the Default profile.
Note Click the Only show service-affecting severities check box to configure the Alarm Profiles
window not to display Minor and some Major alarms that will not affect service.
Step 18 Return to your originating procedure (NTP).
DLP-A519 Apply Alarm Profiles to Ports
Purpose This task applies a custom or default alarm severity profile to a port or
ports.
Tools/Equipment None
Prerequisite Procedures DLP-A518 Create a New or Cloned Alarm Severity Profile, page 22-9
DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher

Cisco ONS 15454 Series Specifications

General

Supported Interfaces	Ethernet
Management	Cisco Transport Controller (CTC), TL1, SNMP
Power Supply	-48 VDC or AC (depending on power supply module)
Operating Temperature	0 to 50°C (32 to 122°F) - varies by module
Storage Temperature	-40°C to 70°C (-40 to 158°F)
Relative Humidity	5 to 95%, noncondensing
Supported Protocols	SONET/SDH, Ethernet, OTN
Platform Type	Multi-service transport platform