19-42
Cisco ONS 15454 Procedure Guide, R5.0
September 2005
Chapter 19 DLPs A200 to A299
DLP-A259 Refresh Ethernet PM Counts at a Different Time Interval
Note To refresh, reset, or clear PM counts, see the “NTP-A253 Change the PM Display” procedure
on page 8-2.
Step 5 Return to your originating procedure (NTP).
DLP-A259 Refresh Ethernet PM Counts at a Different Time Interval
Step 1 In node view, double-click the Ethernet card where you want to view PM counts. The card view appears.
Step 2 Click the Performance tab.
Note For CE-Series and ML-Series cards, click the Performance > Ether Ports tabs or the
Performance > POS Ports tabs.
Step 3 Click the Utilization tab or the History tab.
Step 4 From the Interval drop-down list, choose one of four options:
• 1 min: This option displays the specified PM counts in one-minute time intervals.
• 15 min: This option displays the specified PM counts in 15-minute time intervals.
• 1 hour: This option displays the specified PM counts in one-hour time intervals.
• 1 day: This option displays the specified PM counts in one-day (24 hours) time intervals.
Step 5 Click Refresh. The PM counts refresh with values based on the selected time interval.
Step 6 Return to your originating procedure (NTP).
Purpose This task changes the window view to display specified PM counts in
time intervals depending on the interval option selected.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
To Next Page
Loading...
