Cisco ONS 15454 Series - DLP- A383 Delete a Firewall Tunnel

20-65
Cisco ONS 15454 Procedure Guide, R5.0
March 2005
Chapter 20 DLPs A300 to A399
DLP-A383 Delete a Firewall Tunnel
Step 3 Click Delete.
Step 4 Return to your originating procedure (NTP).
DLP-A383 Delete a Firewall Tunnel
Step 1 Click the Provisioning > Network > Firewall subtabs.
Step 2 Click the firewall tunnel that you want to delete.
Step 3 Click Delete.
Step 4 Return to your originating procedure (NTP).
DLP-A384 Add a Member to a VCAT Circuit
Purpose This task removes a firewall tunnel.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
Purpose This task adds a member to the following virtual concatenated (VCAT)
circuits:
• Software Link Capacity Adjustment Scheme (SW-LCAS) VCAT
circuits on FC_MR-4 (enhanced mode) cards
• Non-LCAS and LCAS circuits on CE-100T-8 cards
Adding a member to a VCAT circuit changes the size of the circuit. The
new members use the VCAT member source, destination, and routing
preference (common fiber or split routing) specified during the VCAT
circuit creation procedure.
Tools/Equipment FC_MR-4 card (enhanced mode) or CE-100T-8 card
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
VCAT circuits must exist on the network. See the “NTP-A264 Create an
Automatically Routed VCAT Circuit” procedure on page 6-86 or the
“NTP-A265 Create a Manually Routed VCAT Circuit” procedure on
page 6-90.
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher