EasyManuals Logo

Cisco ONS 15454 Series User Manual

Cisco ONS 15454 Series
850 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #631 background imageLoading...
Page #631 background image
19-51
Cisco ONS 15454 Procedure Guide, R5.0
September 2005
Chapter 19 DLPs A200 to A299
DLP-A266 Change IP Settings
Step 3 If you want to preview your changed statement and formatting, click the Preview subtab.
Step 4 Click Apply.
Step 5 Return to your originating procedure (NTP).
DLP-A266 Change IP Settings
Caution Changing the node IP address, subnet mask, or IIOP listener port causes the TCC2/TCC2P cards to
reboot. If Ethernet circuits using Spanning Tree Protocol (STP) originate or terminate on E-Series
Ethernet cards installed in the node, circuit traffic will be lost for several minutes while the spanning
trees reconverge. Other circuits are not affected by TCC2/TCC2P reboots.
Step 1 In node view, click the Provisioning > Network > General tabs.
Step 2 Change any of the following:
IP Address
Suppress CTC IP Display
LCD IP Setting
Default Router
Forward DHCP Request To
Net/Subnet Mask Length
<sub> Begins subscript
</sub> Ends subscript
<sup> Begins superscript
</sup> Ends superscript
<u> Starts underline
</u> Ends underline
Purpose This task changes the IP address, subnet mask, default router, DHCP
access, firewall IIOP listener port, LCD IP display, and the SOCKS proxy
server settings.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
DLP-A249 Provision IP Settings, page 19-30
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
Table 19-4 HTML Tags for the Login Legal Disclaimer (continued)
Code Description

Table of Contents

Other manuals for Cisco ONS 15454 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ONS 15454 Series and is the answer not in the manual?

Cisco ONS 15454 Series Specifications

General IconGeneral
Supported InterfacesEthernet
ManagementCisco Transport Controller (CTC), TL1, SNMP
Power Supply-48 VDC or AC (depending on power supply module)
Operating Temperature0 to 50°C (32 to 122°F) - varies by module
Storage Temperature-40°C to 70°C (-40 to 158°F)
Relative Humidity5 to 95%, noncondensing
Supported ProtocolsSONET/SDH, Ethernet, OTN
Platform TypeMulti-service transport platform

Related product manuals