21-19
Cisco ONS 15454 Procedure Guide, R5.0
March 2005
Chapter 21 DLPs A400 to A499
DLP-A440 Change Enhanced FC/FICON Port Settings for the FC_MR-4 Card
Step 4 Click Apply.
Step 5 Return to your originating procedure (NTP).
DLP-A440 Change Enhanced FC/FICON Port Settings for the FC_MR-4 Card
Step 1 In node view, double-click the FC_MR-4 card where you want to change the port settings.
Step 2 Click the Provisioning > Port > Enhanced FC/FICON tabs.
Step 3 Modify any of the settings described in Table 21-5.
Autoadjust
GFP Buffer
Threshold
If checked, guarantees the best utilization of the
SONET/SDH transport in terms of bandwidth and latency.
—
GFP Buffers
Available
Sets the GFP buffer depth. GFP Buffers Available is
editable if Autoadjust GFP Buffer Threshold is unchecked.
For shorter SONET transport distances, Cisco recommends
lower values to decrease latency. For longer SONET
transport distances, Cisco recommends higher values to
provide higher bandwidth.
Numeric. 16 through
1200, multiples of 16
only
Purpose This task changes the enhanced FC/FICON parameters for FC_MR-4
ports.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Table 21-5 FC_MR-4 Card Distance Extension Port Settings
Parameter Description Options
Port (Display only.) The card port number. 1 through 4
Table 21-4 FC_MR-4 Card Distance Extension Port Settings (continued)
Parameter Description Options
To Next Page
Loading...
Need help?
General
