20-53
Cisco ONS 15454 Procedure Guide, R5.0
March 2005
Chapter 20 DLPs A300 to A399
DLP-A369 Provision an OC-N Circuit Route
Step 1 In node view, click the Provisioning > Comm Channels > Provisionable Patchcords tabs. If you are
in network view, click Provisioning > Provisionable Patchcords tabs.
Step 2 Click the provisionable patchcord that you want to delete.
Step 3 Click Delete.
Step 4 In the confirmation dialog box, click Yes .
Step 5 Return to your originating procedure (NTP).
DLP-A369 Provision an OC-N Circuit Route
Step 1 In the Circuit Creation wizard in the Route Review/Edit area, click the source node icon if it is not
already selected.
Step 2 Starting with a span on the source node, click the arrow of the span you want the circuit to travel. To
reverse the direction of the arrow, click the arrow twice.
The arrow turns white. In the Selected Span area, the From and To fields provide span information. The
source STS appears. Figure 20-9 shows an example of a manually routed circuit.
Purpose This task provisions the circuit route for manually routed OC-N circuits.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
The Circuit Creation wizard must be open to complete this task.
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
Need help?
General
