Cisco ONS 15454 Series User Manual

19-52
Cisco ONS 15454 Procedure Guide, R5.0
September 2005
Chapter 19 DLPs A200 to A299
DLP-A268 Apply a Custom Network View Background Map
• TCC CORBA (IIOP) Listener Port
• Gateway Settings
See the “DLP-A249 Provision IP Settings” task on page 19-30 for detailed field descriptions.
Step 3 Click Apply.
Note If you changed a network field that will cause the node to reboot, such as the IP address, subnet
mask, or TCC CORBA Listener Port, the Change Network Configuration confirmation dialog
box appears. If you changed a gateway setting, a confirmation appropriate to the gateway field
appears.
Step 4 If a confirmation dialog box appears, click Yes .
If you changed an IP address, subnet mask length, or TCC CORBA (IIOP) Listener Port, both
ONS 15454 TCC2/TCC2P cards will reboot, one at a time. A TCC2/TCC2P card reboot causes a
temporary loss of connectivity to the node, but traffic is unaffected. See Table 19-2 on page 19-33 for
TCC2/TCC2P reboot behavior.
Step 5 Confirm that the changes appear on the Provisioning > Network > General tabs. If the changes do not
appear, repeat the task. Refer to the Cisco ONS 15454 Troubleshooting Guide as necessary.
Step 6 Return to your originating procedure (NTP).
DLP-A268 Apply a Custom Network View Background Map
Note You can replace the network view background image with any JPEG or GIF image that is accessible on
a local or network drive. If you apply a custom background image, the change is stored in your CTC user
profile on the computer. The change does not affect other CTC users.
Step 1 From the Edit menu, choose Preferences > Map and uncheck the Use Default Map check box.
Step 2 From the View menu, choose Go to Network View.
Step 3 Right-click the network or domain map and choose Set Background Image.
Step 4 Click Browse. Navigate to the graphic file you want to use as a background.
Step 5 Select the file. Click Open.
Step 6 Click Apply and then click OK.
Step 7 If the ONS 15454 icons are not visible, right-click the network view and choose Zoom Out. Repeat this
step until all the ONS 15454 icons are visible.
Purpose This task changes the background image or map in the CTC network view.
Tools/Equipment None
Prerequisite procedures DLP-A60 Log into CTC, page 17-66
Required/As needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher

Cisco ONS 15454 Series Specifications

General

Supported Interfaces	Ethernet
Management	Cisco Transport Controller (CTC), TL1, SNMP
Power Supply	-48 VDC or AC (depending on power supply module)
Operating Temperature	0 to 50°C (32 to 122°F) - varies by module
Storage Temperature	-40°C to 70°C (-40 to 158°F)
Relative Humidity	5 to 95%, noncondensing
Supported Protocols	SONET/SDH, Ethernet, OTN
Platform Type	Multi-service transport platform