8-5
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
Chapter 8 Monitor Performance
NTP-A198 Monitor Ethernet Performance
NTP-A198 Monitor Ethernet Performance
Step 1 Complete the “DLP-A60 Log into CTC” task on page 17-66 at the node that you want to monitor. If you
are already logged in, continue with Step 2.
Step 2 Complete the “DLP-A256 View Ethernet Statistics PM Parameters” task on page 19-38.
Step 3 Complete the “DLP-A257 View Ethernet Utilization PM Parameters” task on page 19-39.
Step 4 Complete the “DLP-A258 View Ethernet History PM Parameters” task on page 19-41.
Step 5 Complete the “DLP-A320 View ML-Series Ether Ports PM Parameters” task on page 20-10.
Step 6 Complete the “DLP-A321 View ML-Series POS Ports PM Parameters” task on page 20-11.
Step 7 Complete the “DLP-A391 View CE-Series Ether Ports and POS Ports Statistics PM Parameters” task on
page 20-87.
Step 8 Complete the “DLP-A392 View CE-Series Ether Ports and POS Ports Utilization PM Parameters” task
on page 20-88.
Step 9 Complete the “DLP-A393 View CE-Series Ether Ports and POS Ports History PM Parameters” task on
page 20-90.
Stop. You have completed this procedure.
NTP-A279 Create or Delete Ethernet RMON Thresholds
Purpose This procedure enables you to view node transmit and receive
performance during selected time intervals on an Ethernet card and port
to detect possible performance problems.
Tools/Equipment None
Prerequisite Procedures Before you monitor performance, be sure you have created the
appropriate circuits and provisioned the card according to your
specifications. For more information, see Chapter 6, “Create Circuits
and VT Tunnels” and Chapter 11, “Change Card Settings.”
Required/As Needed As needed
Onsite/Remote Onsite
Security Level Retrieve or higher
Purpose This procedure creates or deletes Ethernet RMON thresholds for the
ONS 15454.
Tools/Equipment None
Prerequisite Procedures None
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
Need help?
General
