Cisco ONS 15454 Series User Manual

17-58
Cisco ONS 15454 Procedure Guide, R5.0
March 2005
Chapter 17 DLPs A1 to A99
DLP-A51 Set Up a Windows PC for Craft Connection to an ONS 15454 Using Dynamic Host Configuration Protocol
h. Click OK.
i. In the Local Area Connection Properties dialog box, click OK.
j. In the Local Area Connection Status dialog box, click Close.
Step 6 If you have Windows XP installed on your PC, complete the following steps to change its TCP/IP
configuration:
a. From the Windows Start menu, choose Control Panel > Network Connections.
Note If the Network Connections menu item is not available, click Switch to Classic View.
b. From the Network Connections dialog box, click the Local Area Connection icon.
c. From the Local Area Connection Properties dialog box, choose Internet Protocol (TCP/IP), then
click Properties.
d. In the IP Address field, enter an IP address that is identical to the ONS 15454 IP address except for
the last octet. The last octet must be 1 or 3 through 254. This IP address appears on the LCD unless
its display is suppressed during node provisioning.
e. In the Subnet Mask field, type 255.255.255.0.
f. In the Default Gateway field, type the ONS 15454 IP address.
g. Click OK.
h. In the Local Area Connection Properties dialog box, click OK.
i. In the Local Area Connection Status dialog box, click Close.
Step 7 Return to your originating procedure (NTP).
DLP-A51 Set Up a Windows PC for Craft Connection to an ONS 15454 Using
Dynamic Host Configuration Protocol
Note Do not use this task for initial node turn-up. Use the task only if DHCP forwarding is enabled on the
ONS 15454. By default, DHCP is not enabled. To enable it, see the “NTP-A169 Set Up CTC Network
Access” procedure on page 4-7.
Purpose This task sets up your computer for craft connection to the ONS 15454
using Dynamic Host Configuration Protocol (DHCP).
Tools/Equipment None
Prerequisite Procedures NTP-A260 Set Up Computer for CTC, page 3-1
NTP-A169 Set Up CTC Network Access, page 4-7
Required/As Needed As needed
Onsite/Remote Onsite
Security Level None

Cisco ONS 15454 Series Specifications

General

Supported Interfaces	Ethernet
Management	Cisco Transport Controller (CTC), TL1, SNMP
Power Supply	-48 VDC or AC (depending on power supply module)
Operating Temperature	0 to 50°C (32 to 122°F) - varies by module
Storage Temperature	-40°C to 70°C (-40 to 158°F)
Relative Humidity	5 to 95%, noncondensing
Supported Protocols	SONET/SDH, Ethernet, OTN
Platform Type	Multi-service transport platform