17-57
Cisco ONS 15454 Procedure Guide, R5.0
March 2005
Chapter 17 DLPs A1 to A99
DLP-A50 Set Up a Windows PC for Craft Connection to an ONS 15454 on the Same Subnet Using Static IP Addresses
h. In the IP Address field, enter an IP address that is identical to the ONS 15454 IP address except for
the last octet. The last octet must be 1 or 3 through 254. This IP address appears on the LCD unless
its display is suppressed during node provisioning.
i. In the Subnet Mask field, type the same subnet mask as the ONS 15454. The default is
255.255.255.0 (24 bit).
j. Click OK.
k. In the TCP/IP dialog box, click the Gateway tab.
l. In the New Gateway field, type the ONS 15454 IP address. Click Add.
m. Verify that the IP address appears in the Installed Gateways field, then click OK.
n. When the prompt to restart your PC appears, click Ye s.
Step 4 If you have Windows NT 4.0 installed on your PC, complete the following steps to change its TCP/IP
configuration:
a. From the Windows Start menu, choose Settings > Control Panel.
b. In the Control Panel dialog box, click the Network icon.
c. In the Network dialog box, click the Protocols tab, choose TCP/IP Protocol, then click Properties.
d. Click the IP Address tab.
e. In the IP Address window, click Specify an IP address.
f. In the IP Address field, enter an IP address that is identical to the ONS 15454 IP address except for
the last octet. The last octet must be 1 or 3 through 254. This IP address appears on the LCD unless
its display is suppressed during node provisioning.
g. In the Subnet Mask field, type 255.255.255.0.
h. Click Advanced.
i. In the Gateways List, click Add. The TCP/IP Gateway Address dialog box appears.
j. Type the ONS 15454 IP address in the Gateway Address field.
k. Click Add.
l. Click OK.
m. Click Apply.
n. In some cases, Windows NT 4.0 prompts you to reboot your PC. If you receive this prompt, click
Yes.
Step 5 If you have Windows 2000 installed on your PC, complete the following steps to change its TCP/IP
configuration:
a. From the Windows Start menu, choose Settings > Network and Dial-up Connections >
Local Area Connection.
b. In the Local Area Connection Status dialog box, click Properties.
c. On the General tab, choose Internet Protocol (TCP/IP), then click Properties.
d. Click Use the following IP address.
e. In the IP Address field, enter an IP address that is identical to the ONS 15454 IP address except for
the last octet. The last octet must be 1 or 3 through 254. This IP address appears on the LCD unless
its display is suppressed during node provisioning.
f. In the Subnet Mask field, type 255.255.255.0.
g. In the Default Gateway field, type the ONS 15454 IP address.
To Next Page
Loading...
Need help?
General
