Cisco ONS 15454 Series User Manual

17-70
Cisco ONS 15454 Procedure Guide, R5.0
March 2005
Chapter 17 DLPs A1 to A99
DLP-A62 Add a Node to the Current Session or Login Group
Figure 17-27 Login Node Group
Step 6
Return to your originating procedure (NTP).
DLP-A62 Add a Node to the Current Session or Login Group
Step 1 From the CTC File menu, click Add Node.
Step 2 In the Add Node dialog box, enter the node name (or IP address).
Note If the ONS 15454 that you want to add has TCC2P cards installed and the TCC2P secure mode
option is enabled, enter the backplane LAN port IP address.
Step 3 If you want to add the node to the current login group, check Add to current login node group.
Otherwise, leave it unchecked.
Purpose This task adds a node to the current CTC session or login node group.
Tools None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
LAN/WAN (Ethernet)
Three node ring Single
Laptop PC
Node 1
IP Address
192.168.106.143
Node 4
IP Address
192.168.105.119
Node 5
IP Address
192.168.104.109
Node 6
IP Address
192.168.103.199
Node 3Node 2
IP Address
192.168.106.100
55029
Two node ring

Cisco ONS 15454 Series Specifications

General

Supported Interfaces	Ethernet
Management	Cisco Transport Controller (CTC), TL1, SNMP
Power Supply	-48 VDC or AC (depending on power supply module)
Operating Temperature	0 to 50°C (32 to 122°F) - varies by module
Storage Temperature	-40°C to 70°C (-40 to 158°F)
Relative Humidity	5 to 95%, noncondensing
Supported Protocols	SONET/SDH, Ethernet, OTN
Platform Type	Multi-service transport platform