Cisco ONS 15454 Series - DLP- A351 View FC_MR-4 Utilization PM Parameters

20-37
Cisco ONS 15454 Procedure Guide, R5.0
March 2005
Chapter 20 DLPs A300 to A399
DLP-A351 View FC_MR-4 Utilization PM Parameters
Figure 20-6 FC_MR-4 Statistics on the Card View Performance Window
Step 3
Click Refresh. Performance monitoring statistics for each port on the card appear.
Step 4 View the PM parameter names appear in the Param column. The current PM parameter values appear in
the Port # columns. For PM parameter definitions, refer to the “Performance Monitoring” chapter in the
Cisco ONS 15454 Troubleshooting Guide.
Step 5 Return to your originating procedure (NTP).
DLP-A351 View FC_MR-4 Utilization PM Parameters
Step 1 In node view, double-click the FC_MR-4 card where you want to view PM counts. The card view
appears.
Step 2 Click the Performance > Utilization tabs (Figure 20-7).
Purpose This task enables you to view line utilization PM counts on an FC_MR-4
card and port to detect possible performance problems.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
124907
Statistics tab
Performance
tab
Card View
Refresh
button
Auto-refresh
drop-down list
Baseline
button
Clear
button
Help
button