17-2
Cisco ONS 15454 Procedure Guide, R5.0
March 2005
Chapter 17 DLPs A1 to A99
DLP-A2 Inspect the Shelf Assembly
DLP-A2 Inspect the Shelf Assembly
Step 1 Open the shelf using the pinned hex key. For more information, see the “DLP-A8 Open the Front Door”
task on page 17-8.
Step 2 Verify the following:
• The pins are not bent or broken.
• The frame is not bent.
Step 3 If the pins are bent or broken or the frame is bent, call your Cisco sales engineer for a replacement.
Step 4 Close the front door before installing.
Step 5 Return to your originating procedure (NTP).
DLP-A3 Reverse the Mounting Bracket to Fit a 19-inch (482.6 mm) Rack
Caution Use only the fastening hardware provided with the ONS 15454 to prevent loosening, deterioration, and
electromechanical corrosion of the hardware and joined material.
Caution When mounting the ONS 15454 in a frame with a nonconductive coating (such as paint, lacquer, or
enamel) either use the thread-forming screws provided with the ONS 15454 shipping kit, or remove the
coating from the threads to ensure electrical continuity.
Purpose This task verifies that all parts of the shelf assembly are in good condition.
Tools/Equipment Pinned hex (Allen) key for front door
Prerequisite Procedures DLP-A1 Unpack and Verify the Shelf Assembly, page 17-1
Required/As Needed Required
Onsite/Remote Onsite
Security Level None
Purpose This task installs the mounting bracket to convert a 23-inch (584.2 mm)
rack to a 19-inch (482.6 mm) rack.
Tools/Equipment #2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
Prerequisite Procedures None
Required/As Needed As needed
Onsite/Remote Onsite
Security Level None
To Next Page
Loading...
