Cisco ONS 15454 Series User Manual

19-29
Cisco ONS 15454 Procedure Guide, R5.0
September 2005
Chapter 19 DLPs A200 to A299
DLP-A246 Provision E-Series Ethernet Card Mode
DLP-A246 Provision E-Series Ethernet Card Mode
Caution You cannot change the mode while the Ethernet card is carrying circuits. If you want change the card
mode, delete any circuits that it carries first. See the “NTP-A278 Modify and Delete Overhead Circuits”
procedure on page 9-4.
Step 1 In the network view, double-click the node containing the E-Series Ethernet card you want to provision,
then double-click the Ethernet card.
Step 2 Click the Provisioning > Card tabs.
Step 3 In the Card Mode area, choose one of the following:
• For multicard EtherSwitch circuit groups, choose Multicard EtherSwitch Group.
• For single-card EtherSwitch circuits, choose Single-card EtherSwitch.
• For port-mapped circuits, choose Port-mapped.
Step 4 Click Apply.
Step 5 If you are using multicard EtherSwitch circuits, repeat Steps 2 through 4 for all other Ethernet cards in
the node that will carry the multicard EtherSwitch circuits.
Step 6 Repeat Steps 1 through 5 for other nodes as necessary.
Step 7 Return to your originating procedure (NTP).
DLP-A247 Change an OC-N Card
Purpose This task provisions an E-Series Ethernet card for multicard EtherSwitch
Group, single-card EtherSwitch, or port-mapped mode.
Tools/Equipment E-Series Ethernet cards (E100T-12/E100T-G, E1000-2/E1000-2-G) must
be installed.
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task changes an OC-N card while maintaining existing provisioning,
including data communications channels (DCCs), circuits, protection,
timing, and rings. This task is intended to be used when a slot is
preprovisioned and you want to change the optical speed of the card, or
when you have backed out of an automatic span upgrade.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite
Security Level Provisioning or higher

Cisco ONS 15454 Series Specifications

General

Supported Interfaces	Ethernet
Management	Cisco Transport Controller (CTC), TL1, SNMP
Power Supply	-48 VDC or AC (depending on power supply module)
Operating Temperature	0 to 50°C (32 to 122°F) - varies by module
Storage Temperature	-40°C to 70°C (-40 to 158°F)
Relative Humidity	5 to 95%, noncondensing
Supported Protocols	SONET/SDH, Ethernet, OTN
Platform Type	Multi-service transport platform