18-25
Cisco ONS 15454 Procedure Guide, R5.0
March 2007
Chapter 18 DLPs A100 to A199
DLP-A158 Change User Password and Security Level on a Single Node
Step 4 In the Reference Lists area, you can change the following information:
Note Reference lists define up to three timing references for the node and up to six BITS Out
references. BITS Out references define the timing references used by equipment that can be
attached to the node’s BITS Out pins on the backplane. If you attach equipment to BITS Out
pins, you normally attach it to a node with Line mode because equipment near the external
timing reference can be directly wired to the reference.
• NE Reference
• BITS 1 Out
• BITS 2 Out
Step 5 Click Apply. Confirm that the changes appear; of not, repeat the task.
Step 6 Return to your originating procedure (NTP).
DLP-A158 Change User Password and Security Level on a Single Node
Step 1 In node view, click the Provisioning > Security > Users tabs.
Step 2 Click the user whose settings you want to modify, then click Change.
Step 3 In the Change User dialog box, you can:
• Change a user password
• Modify the user security level
• Lock out the user
See the “NTP-A30 Create Users and Assign Security” procedure on page 4-4 for field descriptions.
Step 4 Click OK.
Note User settings that you changed during this task will not appear until that user logs off and logs
back in.
Step 5 Return to your originating procedure (NTP).
Purpose This task changes settings for an existing user at one node.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
To Next Page
Loading...
Need help?
General
