2-14
Cisco ONS 15454 Procedure Guide, R5.0
May 2006
Chapter 2 Install Cards and Fiber-Optic Cable
NTP-A247 Install Fiber-Optic Cables on OC-N Cards
Note In a future software release this card will be detectable through the management interfaces of the ONS
15454.
Step 1 Open the card ejectors.
Step 2 Slide the card along the guide rails into the correct slot.
Step 3 Close the ejectors.
Step 4 Repeat for any remaining unused card slots.
Step 5 Continue with the “NTP-A247 Install Fiber-Optic Cables on OC-N Cards” procedure on page 2-14.
Stop. You have completed this procedure.
NTP-A247 Install Fiber-Optic Cables on OC-N Cards
Warning
Class I (CDRH) and Class 1M (IEC) laser products.
Statement 1055
Warning
Invisible laser radiation could be emitted from the end of the unterminated fiber cable or connector.
Do not stare into the beam directly with optical instruments. Viewing the laser output with certain
optical instruments (for example, eye loupes, magnifiers, and microscopes) within a distance of 100
mm could pose an eye hazard.
Statement 1056
Warning
Use of controls, adjustments, or performing procedures other than those specified may result in
hazardous radiation exposure.
Statement 1057
Warning
On all OC-N cards except someOC192 LR/STM64 LH 1550 cards, the laser is on even when the optical
port is not in service. If an OC-192 card has a safety key, the laser is on when the card is booted and
the safety key is in the on position (labeled 1). The port does not have to be in service for the laser to
be on. The laser is off when the safety key is off (labeled 0).
Purpose This procedure installs fiber-optic cables on OC-N cards or GBICs
according to topology.
Tools/Equipment Fiber-optic cables
Fiber boot
Prerequisite Procedures NTP-A16 Install the OC-N Cards, page 2-6
Required/As Needed As needed
Onsite/Remote Onsite
Security Level None
To Next Page
Loading...
Need help?
General
