15-8
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
Chapter 15 Maintain the Node
NTP-A163 Restore the Node to Factory Configuration
Figure 15-3 Restoring the Database—In-Process Notification
Step 10 Wait for the file to complete the transfer to the TCC2/TCC2P card.
Step 11 Click OK when the “Lost connection to node, changing to Network View” dialog box appears. Wait for
the node to reconnect.
Step 12 If you cleared a switch in Step 3, reapply the switch as needed.
Stop. You have completed this procedure.
NTP-A163 Restore the Node to Factory Configuration
Caution Cisco strongly recommends that you keep different node databases in separate folders. This is because
the reinit tool chooses the first product-specific software package in the specified directory if you use
the Search Path field instead of the Package and Database fields. You might accidentally copy an
incorrect database if multiple databases are kept in the specified directory.
Caution Restoring a node to the factory configuration deletes all cross-connects on the node.
Purpose This procedure reinitializes the ONS 15454 using the CTC
reinitialization tool. Reinitialization uploads a new software package to
the TCC2/TCC2P cards, clears the node database, and restores the
factory default parameters.
Tools/Equipment ONS 15454 SONET System Software CD, Version 5.0.x
JRE 1.4.2 must be installed on the computer to log into the node when
the reinitialization is complete. The reinitialization tool can run on
JRE 1.3.1_02 or JRE 1.4.2.
Prerequisite Procedures NTP-A108 Back Up the Database, page 15-4
NTP-A260 Set Up Computer for CTC, page 3-1
One of the following:
• NTP-A234 Set Up CTC Computer for Local Craft Connection to the
ONS 15454, page 3-2, or
• NTP-A235 Set Up a CTC Computer for a Corporate LAN
Connection to the ONS 15454, page 3-4
Required/As Needed As needed
Onsite/Remote Onsite
Security Level Superuser
To Next Page
Loading...
