19-23
Cisco ONS 15454 Procedure Guide, R5.0
September 2005
Chapter 19 DLPs A200 to A299
DLP-A241 Clear a BLSR Manual Ring Switch
DLP-A241 Clear a BLSR Manual Ring Switch
Step 1 From the View menu, choose Go to Network View.
Step 2 Click the Provisioning > BLSR tabs.
Step 3 Choose the BLSR and click Edit.
Tip To move an icon to a new location, for example, to see BLSR channel (port) information more
clearly, click an icon on the Edit BLSR network graphic and while pressing Ctrl, drag the icon
to a new location.
Step 4 Right-click the BLSR node channel (port) where the Manual ring switch was applied and choose
Set West Protection Operation or Set East Protection Operation, as applicable.
Step 5 In the dialog box, choose CLEAR from the drop-down list. Click OK.
Step 6 Click Ye s on the Confirm BLSR Operation dialog box. The letter “M” is removed from the channel (port)
and the span turns green on the network view map.
Step 7 From the File menu, choose Close.
Step 8 Return to your originating procedure (NTP).
DLP-A242 Create a BLSR on a Single Node
Step 1 In node view, click the Provisioning > BLSR tabs.
Step 2 In the Suggestion dialog box, click OK.
Step 3 In the Create BLSR dialog box, enter the BLSR information:
Purpose This task clears a BLSR Manual ring switch.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task creates a BLSR on a single node. Use it to add a node to an
existing BLSR or when you delete and then recreate a BLSR temporarily
on one node.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite
Security Level Provisioning or higher
To Next Page
Loading...
