20-85
Cisco ONS 15454 Procedure Guide, R5.0
March 2005
Chapter 20 DLPs A300 to A399
DLP-A390 View Alarms
Note The threshold value appears after the circuit is created.
Step 7 Return to your originating procedure (NTP).
DLP-A390 View Alarms
Step 1 In the card, node, or network view, click the Alarms tab to view the alarms for that card, node, or
network (Figure 20-17).
Figure 20-17 CTC Node View
Table 20-12 lists the columns in the Alarms window and their descriptions.
Purpose Use this task to view current alarms on a card, node, or network.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
