8-7
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
Chapter 8 Monitor Performance
NTP-A285 Monitor FC_MR-4 Performance
NTP-A285 Monitor FC_MR-4 Performance
Step 1 Complete the “DLP-A60 Log into CTC” task on page 17-66 at the node that you want to monitor. If you
are already logged in, continue with Step 2.
Step 2 Complete the “DLP-A350 View FC_MR-4 Statistics PM Parameters” task on page 20-36.
Step 3 Complete the “DLP-A351 View FC_MR-4 Utilization PM Parameters” task on page 20-37.
Step 4 Complete the “DLP-A352 View FC_MR-4 History PM Parameters” task on page 20-38.
Stop. You have completed this procedure.
NTP-A289 Create or Delete FC_MR-4 RMON Thresholds
Step 1 Complete the “DLP-A60 Log into CTC” task on page 17-66. If you are already logged in, continue with
Step 2.
Step 2 Perform any of the following tasks as needed:
• DLP-A357 Create FC_MR-4 RMON Alarm Thresholds, page 20-41
• DLP-A358 Delete FC_MR-4 RMON Alarm Thresholds, page 20-45
Stop. You have completed this procedure.
Purpose This procedure enables you to view node transmit and receive
performance during selected time intervals on an FC_MR-4 card and
port to detect possible performance problems.
Tools/Equipment None
Prerequisite Procedures Before you monitor performance, be sure you have created the
appropriate circuits and provisioned the card according to your
specifications. For more information, see Chapter 6, “Create Circuits
and VT Tunnels” and Chapter 11, “Change Card Settings.”
Required/As Needed As needed
Onsite/Remote Onsite
Security Level Retrieve or higher
Purpose Use this procedure to create or delete FC_MR-4 RMON thresholds for the
ONS 15454.
Tools/Equipment None
Prerequisite Procedures None
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
