20-49
Cisco ONS 15454 Procedure Guide, R5.0
March 2005
Chapter 20 DLPs A300 to A399
DLP-A364 Reset the TCC2/TCC2P Card Using CTC
Note Some or all of the following alarms will appear until all the BLSR nodes are provisioned: E-W
MISMATCH, RING MISMATCH, APSCIMP, APSDFLTK, and BLSROSYNC. The alarms will
clear after you configure all the nodes in the BLSR.
Step 6 From the View menu, choose Go to Other Node.
Step 7 In the Select Node dialog box, choose the next node that you want to add to the BLSR.
Step 8 Repeat Steps 1 through 7 at each node that you want to add to the BLSR. When all nodes have been
added, continue with Step 9.
Step 9 From the View menu, choose Go to Network View. After 10 to 15 seconds, verify the following:
• A green span line appears between all BLSR nodes.
• All E-W MISMATCH, RING MISMATCH, APSCIMP, DFLTK, and BLSROSYNC alarms are
cleared.
Step 10 Return to your originating procedure (NTP).
DLP-A364 Reset the TCC2/TCC2P Card Using CTC
Warning
Do not reach into a vacant slot or chassis while you install or remove a module or a fan. Exposed
circuitry could constitute an energy hazard.
Statement 206
Note Before you reset the TCC2/TCC2P card, you should wait at least 60 seconds after the last provisioning
change you made to avoid losing any changes to the database.
Note When a software reset is performed on an active TCC2/TCC2P card, the AIC or AIC-I card goes through
an initialization process and also resets. The AIC or AIC-I card reset is normal and happens each time
an active TCC2/TCC2P card goes through a software-initiated reset.
Step 1 Complete the “DLP-A60 Log into CTC” task on page 17-66 at the node where you want to reset the
TCC2/TCC2P card. If you are already logged in, continue with Step 2.
Step 2 In node view, right-click the TCC2/TCC2P card to reveal a shortcut menu.
Step 3 Click Reset Card.
Purpose This task resets the TCC2/TCC2P card and switches the node to the
redundant card.
Tools/Equipment None
Prerequisite Procedures DLP-A36 Install the TCC2/TCC2P Cards, page 17-42
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
To Next Page
Loading...
Need help?
General
