20-81
Cisco ONS 15454 Procedure Guide, R5.0
March 2005
Chapter 20 DLPs A300 to A399
DLP-A388 Change Line and Threshold Settings for the DS3/EC1-48 Cards
Step 4 Modify any of the settings found under these subtabs. For definitions of the line settings, see Table 20-8.
For definitions of the line threshold settings, see Table 20-9 on page 20-83. For definitions of the
electrical path threshold settings, see Table 20-10 on page 20-83. For definitions of the SONET
threshold settings, see Table 20-11 on page 20-84.
Step 5 Click Apply.
Step 6 Repeat Steps 3 through 5 for each subtab that has parameters you want to provision.
Table 20-8 describes the values on the Provisioning > Line tabs for the DS3/EC1-48 cards.
Table 20-8 Line Options for the DS3/EC1-48Card
Parameter Description Options
Port Sets the port number. 1 to 48
Port Name Sets the port name. User-defined, up to 32 alphanumeric/special
characters. Blank by default.
See the “DLP-A314 Assign a Name to a
Port” task on page 20-8.
Admin State Sets the port service state unless network
conditions prevent the change.
• IS—Puts the port in-service. The port
service state changes to IS-NR.
• IS,AINS—Puts the port in automatic
in-service. The port service state
changes to OOS-AU,AINS.
• OOS,DSBLD—Removes the port from
service and disables it. The port service
state changes to OOS-MA,DSBLD.
• OOS,MT—Removes the port from
service for maintenance. The port
service state changes to OOS-MA,MT.
To Next Page
Loading...
