20-88
Cisco ONS 15454 Procedure Guide, R5.0
March 2005
Chapter 20 DLPs A300 to A399
DLP-A392 View CE-Series Ether Ports and POS Ports Utilization PM Parameters
Note To refresh, reset, or clear PM counts, see the “NTP-A253 Change the PM Display” procedure
on page 8-2.
Step 5 Return to your originating procedure (NTP).
DLP-A392 View CE-Series Ether Ports and POS Ports Utilization PM Parameters
Step 1 In node view, double-click the CE-Series Ethernet card where you want to view PM counts. The card
view appears.
Step 2 Click the Performance > Ether Ports > Utilization (Figure 20-19) or Performance > POS Ports >
Utilization tabs.
Purpose This task enables you to view CE-Series Ether Port and POS Port
utilization PM counts at selected time intervals to detect possible
performance problems.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
To Next Page
Loading...
