Cisco ONS 15454 Series User Manual

20-10
Cisco ONS 15454 Procedure Guide, R5.0
March 2005
Chapter 20 DLPs A300 to A399
DLP-A320 View ML-Series Ether Ports PM Parameters
Step 7 In the Select Applicable Nodes area, uncheck any nodes where you do not want to change the user’s
settings (all network nodes are selected by default).
Step 8 Click OK.
Step 9 Return to your originating procedure (NTP).
DLP-A320 View ML-Series Ether Ports PM Parameters
Note For ML-Series card provisioning, see the Ethernet Card Software Feature and Configuration Guide for
the Cisco ONS 15454 SDH, Cisco ONS 15454, and Cisco ONS 15327.
Step 1 In node view, double-click the ML-Series Ethernet card where you want to view PM counts. The card
view appears.
Step 2 Click the Performance > Ether Ports tabs (Figure 20-1).
Purpose This task enables you to view ML-Series Ethernet port performance
monitoring (PM) counts at selected time intervals to detect possible
performance problems.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher

Cisco ONS 15454 Series Specifications

General

Supported Interfaces	Ethernet
Management	Cisco Transport Controller (CTC), TL1, SNMP
Power Supply	-48 VDC or AC (depending on power supply module)
Operating Temperature	0 to 50°C (32 to 122°F) - varies by module
Storage Temperature	-40°C to 70°C (-40 to 158°F)
Relative Humidity	5 to 95%, noncondensing
Supported Protocols	SONET/SDH, Ethernet, OTN
Platform Type	Multi-service transport platform