20-11
Cisco ONS 15454 Procedure Guide, R5.0
March 2005
Chapter 20 DLPs A300 to A399
DLP-A321 View ML-Series POS Ports PM Parameters
Figure 20-1 Ether Ports on the ML-Series Card View Performance Window
Step 3
Click Refresh. Performance monitoring statistics for each port on the card appear.
Step 4 View the PM parameter names that appear in the Param column. The PM parameter values appear in the
Port # columns. For PM parameter definitions, refer to the “Performance Monitoring” chapter in the
Cisco ONS 15454 Troubleshooting Guide.
Note To refresh, reset, or clear PM counts, see the “NTP-A253 Change the PM Display” procedure
on page 8-2.
Step 5 Return to your originating procedure (NTP).
DLP-A321 View ML-Series POS Ports PM Parameters
124912
Ether Ports
tab
Performance
tab
Card View
Baseline
button
Help
button
Auto-refresh
menu
Refresh
button
Purpose This task enables you to view packet-over-SONET (POS) port PM
counts at selected time intervals on an ML-Series Ethernet card and port
to detect possible performance problems.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-66
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
To Next Page
Loading...
Need help?
General
