Cisco ONS 15454 Series - Page 656

20-12
Cisco ONS 15454 Procedure Guide, R5.0
March 2005
Chapter 20 DLPs A300 to A399
DLP-A321 View ML-Series POS Ports PM Parameters
Note For ML-Series card provisioning, see the Ethernet Card Software Feature and Configuration Guide for
the Cisco ONS 15454 SDH, Cisco ONS 15454, and Cisco ONS 15327.
Step 1 In node view, double-click the ML-Series Ethernet card where you want to view PM counts. The card
view appears.
Step 2 Click the Performance > POS Ports tabs (Figure 20-2).
Figure 20-2 POS Ports on the ML-Series Card View Performance Window
Step 3
Click Refresh. Performance monitoring statistics for each port on the card appear.
Step 4 View the PM parameter names that appear in the Param column. The PM parameter values appear in the
Port # columns. For PM parameter definitions refer to the “Performance Monitoring” chapter in the
Cisco ONS 15454 Troubleshooting Guide.
Note To refresh, reset, or clear PM counts, see the “NTP-A253 Change the PM Display” procedure
on page 8-2.
Step 5 Return to your originating procedure (NTP).
124912
Ether Ports
tab
Performance
tab
Card View
Baseline
button
Help
button
Auto-refresh
menu
Refresh
button