Cisco ONS 15454 Series User Manual

10-7
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
Chapter 10 Change Node Settings
NTP-A87 Change SNMP Settings
Step 1 Complete the “DLP-A60 Log into CTC” task on page 17-66. If you are already logged in, continue with
Step 2.
Step 2 Complete the “NTP-A108 Back Up the Database” procedure on page 15-4.
Step 3 Perform any of the following tasks as needed:
• DLP-A273 Modify SNMP Trap Destinations, page 19-56
• DLP-A163 Delete SNMP Trap Destinations, page 18-28
Step 4 Complete the “NTP-A108 Back Up the Database” procedure on page 15-4.
Stop. You have completed this procedure.

Cisco ONS 15454 Series Specifications

General

Supported Interfaces	Ethernet
Management	Cisco Transport Controller (CTC), TL1, SNMP
Power Supply	-48 VDC or AC (depending on power supply module)
Operating Temperature	0 to 50°C (32 to 122°F) - varies by module
Storage Temperature	-40°C to 70°C (-40 to 158°F)
Relative Humidity	5 to 95%, noncondensing
Supported Protocols	SONET/SDH, Ethernet, OTN
Platform Type	Multi-service transport platform