Cisco ONS 15454 Series User Manual

11-7
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
Chapter 11 Change Card Settings
NTP-A297 Change Card Service State
Stop. You have completed this procedure.
OOS,MT OOS-AU,AINS & MEA
(Out-of-Service and Autonomous,Auto
In-Service and Mismatched Equipment)
OOS-AUMA,MEA & MT
(Out-of-Service and Autonomous
Management,Mismatched Equipment
and Maintenance)
OOS,MT OOS-AU,UEQ
(Out-of-Service and
Autonomous,Unequipped)
OOS-AUMA,MT & UEQ
(Out-of-Service and Autonomous
Management,Maintenance and
Unequipped)
OOS,MT IS-NR
(In-Service and Normal)
OOS-MA,MT
(Out-of-Service and
Management,Maintenance)
Table 11-1 Cisco ONS 15454 Card State Transitions (continued)
Admin State Original Service State Next Service State

Cisco ONS 15454 Series Specifications

General

Supported Interfaces	Ethernet
Management	Cisco Transport Controller (CTC), TL1, SNMP
Power Supply	-48 VDC or AC (depending on power supply module)
Operating Temperature	0 to 50°C (32 to 122°F) - varies by module
Storage Temperature	-40°C to 70°C (-40 to 158°F)
Relative Humidity	5 to 95%, noncondensing
Supported Protocols	SONET/SDH, Ethernet, OTN
Platform Type	Multi-service transport platform