Cisco ONS 15454 Series - Page 560

18-50
Cisco ONS 15454 Procedure Guide, R5.0
March 2007
Chapter 18 DLPs A100 to A199
DLP-A170 Change Line Transmission Settings for OC-N Cards
Admin SSM Allows you to override the
synchronization traceability
unknown (STU) value (default
setting).
• PRS: Primary Reference Source (Stratum 1)
• ST2: Stratum 2
• TNC: Transit node clock
• ST3E: Stratum 3E
• ST3: Stratum 3
• SMC: SONET minimum clock
• ST4: Stratum 4
PJSTSMon# Sets the STS that will be used for
pointer justification. If set to 0,
no STS is monitored. Only one
STS can be monitored on each
OC-N port.
• 0 - 3 (OC-3, per port)
• 0 - 12 (OC-12)
• 0 - 48 (OC-48)
• 0 - 192 (OC-192)
Admin State Sets the port service state unless
network conditions prevent the
change.
• IS—Puts the port in-service. The port service state
changes to IS-NR.
• IS,AINS—Puts the port in automatic in-service.
The port service state changes to OOS-AU,AINS.
• OOS,DSBLD—Removes the port from service
and disables it. The port service state changes to
OOS-MA,DSBLD.
• OOS,MT—Removes the port from service for
maintenance. The port service state changes to
OOS-MA,MT.
Service
State
Identifies the autonomously
generated state that gives the
overall condition of the port.
Service states appear in the
format: Primary State-Primary
State Qualifier, Secondary State.
• IS-NR—(In-Service and Normal) The port is fully
operational and performing as provisioned.
• OOS-AU,AINS—(Out-Of-Service and
Autonomous, Automatic In-Service) The port is
out-of-service, but traffic is carried. Alarm
reporting is suppressed. The ONS node monitors
the ports for an error-free signal. After an
error-free signal is detected, the port stays in
OOS-AU,AINS state for the duration of the soak
period. After the soak period ends, the port service
state changes to IS-NR.
• OOS-MA,DSBLD—(Out-of-Service and
Management, Disabled) The port is out-of-service
and unable to carry traffic.
• OOS-MA,MT—(Out-of-Service and
Management, Maintenance) The port is
out-of-service for maintenance. Alarm reporting is
suppressed, but traffic is carried and loopbacks are
allowed.
Table 18-21 OC-N Card Line Settings (continued)
Parameter Description Options