Cisco ONS 15454 Series - Page 90

2-4
Cisco ONS 15454 Procedure Guide, R5.0
May 2006
Chapter 2 Install Cards and Fiber-Optic Cable
NTP-A15 Install the Common Control Cards
In Table 2-2, X indicates that a card is supported in the slot. MS identifies Slots 1 through 4 and 14
through 17 (multispeed slot). HS identifices Slots 5, 6, 12, and 13 (high-speed slot). The XC10G card
requires the ANSI shelf (5454-SA-ANSI) or the high-density shelf (15454-SA-HD).
OC12 LR/STM4
LH 1310
XXXXXX XXXXXX
OC12 LR/STM4
LH 1550
XXXXXX XXXXXX
OC12 IR/STM4
SH 1310-4
Not supported with XCVT cards. Requires XC10G cards.
OC48 IR 1310
4
XX XX
OC48 LR 1550 X X X X
OC48 IR/STM16
SH AS 1310
XX XX
OC48
LR/STM16 LH
AS 1550
XX XX
OC48-ELR/STM
16 EH 100 GHz
XX XX
OC48 ELR 200
GHz
XX XX
OC192
SR/STM64 IO
1310
Not supported with XCVT cards. Requires XC10G cards.
OC192
IR/STM64 SH
1550
Not supported with XCVT cards. Requires XC10G cards.
OC192
LR/STM64 LH
1550
Not supported with XCVT cards. Requires XC10G cards.
OC192
LR/STM64 LH
ITU 15xx.xx
Not supported with XCVT cards. Requires XC10G cards.
FC_MR-4 X X X X
1. This identifies 1:N cards that operate as normal DS1 or DS3 cards when installed in certain slots.
2. This DS3 card cannot be used in this slot if used with a high-density EIA or in a 1:N configuration.
3. This card can only be used with the XCVT card, not the XC card.
4. The OC48AS will operate in Slots 5, 6, 12, and 13 with the XC/XCVT in R3.4 through R4.6, and the OC48AS will operate in Slots 5, 6, 12, and 13 with
the XCVT in R5.0 and later. In Release R3.3 and earlier, OC48AS with XC/XCVT is not supported.
Table 2-1 Card and Slot Compatibility for the XCVT Card (continued)
Slot 1234567891011121314151617
Type MS MS MS MS HS HS TCC XC AIC XC TCC HS HS MS MS MS MS