AKD User Guide | DRV Parameters and Commands
DRV.BLINKDISPLAY
General Information
Type Command
Description Causes the display to blink for 10 seconds.
Units N/A
Range N/A
Default Value N/A
Data Type N/A
See Also N/A
Start Version M_01-00-00-000
Description
DRV.BLINKDISPLAY causes the drive display located on the front of the drive to blink for 10 seconds.
This command allows the user to identify the drive that is currently communicating with
WorkBench.
344 Kollmorgen | December 2010
To Next Page
Loading...
