AKD User Guide | GEAR Parameters
GEAR.VMAX
General Information
Type R/W Parameter
Description
Reads the maximum allowed velocity value; active in opmode 2 (position)
only.
Units
Depends on UNIT.ACCROTARY or UNIT.ACCLINEAR
Rotary: rpm, rps, deg/s, (PIN/POUT)/s, rad/s
Linear: counts/s, mm/s, µm/s, (PIN/POUT)/s
Range
Rotary:
0.001 to 12,000.000 rpm
0.001 to 200.000 rps
0.001 to 72,000.000 deg/s
0.001 to 1,000.000 (PIN/POUT)/s
0.001 to 1256.637 rad/s
Linear:
0.001 to 0.200 counts/s
0.001*MOTOR.PITCH to 200.000*MOTOR.PITCH mm/s
0.004*MOTOR.PITCH to 200,000.000*MOTOR.PITCH µm/sec
0.001 to 1,000.000 (PIN/POUT)/s
Default Value
Rotary:
3,000 rpm
50 rps
18,000.002 deg/s
250.000 (PIN/POUT)/s
314.159 rad/s
Linear:
0.050 counts/s
50 mm/s
50,000.004MOTOR.PITCH µm/s
250.000 (PIN/POUT)/s
Data Type Float
See Also N/A
Start Version M_01-00-00-000
Fieldbus Index/Subindex Object Start Version
Modbus 382 M_01-03-00-000
Description
This parameter limits the maximum velocity of the slave drive.
Related Topics
10.7 Electronic Gearing
436 Kollmorgen | December 2010
To Next Page
Loading...
