Siemens SINAMICS G150 - Page 1219

SINAMICS G130/G150 List Manual (LH2), 04/2014, A5E03263479A
1219
3 Function diagrams
3.19 Data sets
Fig. 3-167 8560 – Command Data Sets (CDS)
- 8560 -
Function diagram
87654321
fp_8560_54_eng.vsd
DO: SERVO, VECTOR
S120/S150/G130/G150
03.07.13 V04.07.00
Data sets - Command Data Sets (CDS)
Not relevant
Copy CDS, source
p0809[0] (0)
CDS selected
r0836.0
r0836
CDS effective
r0050.0
r0050
r0836.1
r0050.1
Copy CDS, target
p0809[1] (1)
Copy CDS, start
p0809[2] (0)
BI: p0810 = "0"
CDS0 selected
r0836.0 = 0
BI: p0810 = "1"
CDS1 selected
r0836.0 = 1
CDS0 effective
r0050.0 = 0
CDS1 effective
r0050.0 = 1
t
Example:
Change over Command Data Set
CDS0 --> CDS1
t
t
Drive n
Drive 2
Drive 1
<1>
CDS count
p0170 (1, 2)
<1> For SERVO, the following applies: Min / Max / Factory setting: 1 / 2 / 2
For VECTOR, the following applies: Min / Max / Factory setting: 2 / 4 / 2
(0)
CDS select., bit 0
p0810
(0)
CDS select., bit 1
p0811
CDS3
CDS2
CDS1
CDS0