5. Insert the input simulator as shown in the picture.
6. Tighten all screws of the onboard I/O clamps (max. torque 1.2 Nm).
7. Plug the terminal block for power supply of the TA571-SIM to the connector of the pro-
cessor module.
8. Connect the processor module power supply wires (24 VDC or 100-240 VAC). See
PM55x/PM56x
Ä
Chapter 1.2.1.1.4 “Power Supply” on page 27
With input simulator TA571-SIM, the digital 24 VDC inputs DI0...DI5 of can be turned OFF and
ON separately:
● If the lever of the switch is on the right side, the input is ON.
● If the lever of the switch is on the left side, the input is OFF.
To remove the input simulator follow the procedure shown below.
Usage
Removal
2019/04/17 3ADR010121, 13, en_US 1125
To Next Page
Loading...
