Cisco ONS 15454 Series - Page 20

Figures
xx
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
Figure 5-14 Subtended BLSRs on the Network Map 5-40
Figure 6-1 Setting Circuit Attributes for a DS-1 Circuit 6-8
Figure 6-2 Setting Circuit Routing Preferences for a DS-1 Circuit 6-9
Figure 6-3 Setting Circuit Attributes for a Unidirectional DS-1 Circuit 6-15
Figure 6-4 Setting Circuit Attributes for a DS-3 Circuit 6-20
Figure 6-5 Setting Circuit Routing Preferences for a DS-3 Circuit 6-21
Figure 6-6 Setting Circuit Attributes for a Unidirectional DS-3 Circuit 6-27
Figure 6-7 Setting Attributes for a VT Tunnel 6-30
Figure 6-8 Setting Attributes for a VT Aggregation Point 6-34
Figure 6-9 Setting Circuit Attributes for an OC-N Circuit 6-39
Figure 6-10 Setting Circuit Routing Preferences for an OC-N Circuit 6-40
Figure 6-11 Selecting BLSR DRI Primary and Secondary Node Assignments 6-42
Figure 6-12 Selecting BLSR DRI Primary and Secondary Node Assignments (Manual Routing) 6-46
Figure 6-13 Setting Circuit Attributes for a Unidirectional OC-N Circuit 6-48
Figure 6-14 Two-Port Bidirectional Transponder Mode 6-79
Figure 6-15 One-Port Bidirectional Transponder Mode 6-80
Figure 6-16 Two-Port Unidirectional Transponder Mode 6-81
Figure 6-17 Setting VCAT Circuit Attributes 6-87
Figure 6-18 Automatically Routing a VCAT Circuit 6-88
Figure 6-19 VCAT Circuit Route Constraints 6-89
Figure 7-1 Select Affected Circuits Option 7-5
Figure 7-2 Viewing Alarm-Affected Circuits 7-5
Figure 7-3 Shelf LCD Panel 7-6
Figure 7-4 AIC Card External Alarms 7-10
Figure 7-5 Provisioning External Alarms On The AIC-I Card 7-12
Figure 8-1 Viewing Electrical Card Performance Monitoring Information 8-4
Figure 9-1 VT1.5 Monitor Circuit Received at an EC1-12 Port 9-6
Figure 12-1 Span Upgrade Wizard 12-14
Figure 13-1 Selecting Protection Group Ports 13-3
Figure 13-2 Refibering the Protect Path 13-4
Figure 13-3 Linear ADM to BLSR Conversion 13-10
Figure 14-1 Three-Node, Two-Fiber BLSR Before a Fourth Node Is Added 14-2
Figure 14-2 Three-Node, Four-Fiber BLSR Before a Fourth Node is Added 14-3
Figure 14-3 Four-Node, Two-Fiber BLSR Before a Node Is Removed 14-7
Figure 14-4 Selecting Protection Group Ports 14-15