FIGURES
xix
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
Figure 1-1 Installing the Fan-Tray Assembly 1-12
Figure 1-2 Replace Backplane Screws with Standoffs 1-13
Figure 1-3 Installing Standoffs and the AEP 1-14
Figure 1-4 AEP Wire-Wrap Connections to Backplane Pins 1-14
Figure 1-5 Installing the AEP Cover 1-17
Figure 1-6 Alarm Input Connector 1-19
Figure 1-7 Alarm Output Connector 1-20
Figure 1-8 Mounting Holes on the UBIC-V EIA 1-24
Figure 1-9 Mounting Holes on the UBIC-H 1-25
Figure 1-10 Mounting Holes on the All Other EIA Types 1-26
Figure 1-11 EIA Labelling on the Mounting Bar 1-27
Figure 1-12 Installing the Rear Cover Onto the Mounting Bars 1-28
Figure 1-13 Installing the Rear Cover with Standoffs 1-29
Figure 2-1 Installing the Door Ground Strap Retrofit Kit 2-19
Figure 2-2 Shelf Assembly with Door Ground Strap Retrofit Kit Installed 2-20
Figure 4-1 Nodes Behind a Firewall 4-8
Figure 4-2 CTC Computer and ONS 15454s Residing Behind Firewalls 4-9
Figure 4-3 Creating an SNMP Trap 4-12
Figure 5-1 Linear ADM Configuration 5-7
Figure 5-2 Four-Node, Two-Fiber BLSR Fiber Connection Example 5-10
Figure 5-3 Four-Node, Four-Fiber BLSR Fiber Connection Example 5-11
Figure 5-4 Traditional Two-Fiber BLSR DRI Fiber Connection Example 5-18
Figure 5-5 Integrated Two-Fiber BLSR DRI Example 5-20
Figure 5-6 Path Protection Fiber Connection Example 5-21
Figure 5-7 Traditional Path Protection DRI Fiber Connection Example 5-25
Figure 5-8 Integrated Path Protection DRI Example 5-27
Figure 5-9 Traditional BLSR to Path Protection DRI Fiber Connection Example 5-29
Figure 5-10 Integrated BLSR to Path Protection DRI Example 5-31
Figure 5-11 ONS 15454 Open-Ended Path Protection Configurations Fiber Connection Example 5-32
Figure 5-12 Path Protection Subtended from a BLSR 5-36
Figure 5-13 BLSR Subtended from a BLSR 5-39
To Next Page
Loading...
Need help?
General
