16-3
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
Chapter 16 Power Down the Node
NTP-A114 Power Down the Node
Step 9 In node view, right-click an installed card and click Delete.
Step 10 Click Ye s.
Step 11 After you have deleted the card, open the card ejectors and remove it from the node.
Step 12 Repeat Step 7 through 11 for each installed card.
Note You cannot delete an Advanced Timing, Communications, and Control (TCC2) card in
Cisco Transport Controller (CTC). Physically remove it after all the other cards have been
deleted and removed.
Step 13 Shut off the power from the power supply that feeds the node.
Step 14 Disconnect the node from its external fuse source.
Step 15 Store all the cards you removed and update inventory records according to local site practice.
Stop. You have completed this procedure.
To Next Page
Loading...
