Cisco ONS 15454 Series - Page 43

Tasks
xliii
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
DLP-A439 Change Distance Extension Port Settings for the FC_MR-4 Card 21-18
DLP-A440 Change Enhanced FC/FICON Port Settings for the FC_MR-4 Card 21-19
DLP-A441 Install Electrical Cables on the UBIC-H EIAs 21-21
DLP-A442 Verify Pass-Through Circuits 21-23
DLP-A469 Install GBIC or SFP Connectors 21-24
DLP-A470 Remove GBIC or SFP Connectors 21-26
DLP-A498 Switch Between TDM and DWDM Network Views 21-27
DLP-A507 View OC-N PM Parameters 22-1
DLP-A510 Provision a DS-3 Circuit Source and Destination 22-3
DLP-A511 Change Node Access and PM Clearing Privilege 22-4
DLP-A515 Print CTC Data 22-5
DLP-A516 Export CTC Data 22-6
DLP-A517 View Alarm or Event History 22-8
DLP-A518 Create a New or Cloned Alarm Severity Profile 22-9
DLP-A519 Apply Alarm Profiles to Ports 22-12
DLP-A520 Delete Alarm Severity Profiles 22-14
DLP-A521 Modify Alarm, Condition, and History Filtering Parameters 22-16
DLP-A522 Suppress Alarm Reporting 22-17
DLP-A523 Discontinue Alarm Suppression 22-19
DLP-A524 Download an Alarm Severity Profile 22-20
DLP-A526 Change Line and Threshold Settings for the DS3i-N-12 Cards 22-21
DLP-A528 Change the Default Network View Background Map 22-25
DLP-A529 Delete Ethernet RMON Alarm Thresholds 22-26
DLP-A530 Install the Tie-Down Bar 22-27
DLP-A533 Create Ethernet RMON Alarm Thresholds 22-28
DLP-A553 Upgrade Low-Density Electrical Cards in a 1:N Configuration to High-Density Electrical
Cards
22-34
DLP-A554 Upgrade Low-Density Electrical Cards in a 1:1 Configuration to High-Density Electrical Cards 22-37