Cisco ONS 15454 Series - Page 42

Tasks
xlii
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
DLP-A377 Provision Section DCC Terminations 20-61
DLP-A378 Provision Line DCC Terminations 20-62
DLP-A380 Provision a Proxy Tunnel 20-63
DLP-A381 Provision a Firewall Tunnel 20-64
DLP-A382 Delete a Proxy Tunnel 20-64
DLP-A383 Delete a Firewall Tunnel 20-65
DLP-A384 Add a Member to a VCAT Circuit 20-65
DLP-A385 Delete a Member from a VCAT Circuit 20-69
DLP-A386 Install Electrical Cables on the UBIC-V EIAs 20-70
DLP-A387 Change Line and Threshold Settings for the DS3XM-12 Card 20-74
DLP-A388 Change Line and Threshold Settings for the DS3/EC1-48 Cards 20-80
DLP-A390 View Alarms 20-85
DLP-A391 View CE-Series Ether Ports and POS Ports Statistics PM Parameters 20-87
DLP-A392 View CE-Series Ether Ports and POS Ports Utilization PM Parameters 20-88
DLP-A393 View CE-Series Ether Ports and POS Ports History PM Parameters 20-90
DLP-A394 View DS-N/SONET PM Parameters for the DS3XM-12 Card 20-91
DLP-A395 View BFDL PM Parameters for the DS3XM-12 Card 20-93
DLP-A397 Manually Route a Path Protection Circuit for a Topology Upgrade 20-95
DLP-A398 Automatically Route a Path Protection Circuit for a Topology Upgrade 20-95
DLP-A399 Install a UBIC-H EIA 20-97
DLP-A412 Install the DCU Shelf Assembly 21-1
DLP-A416 View Circuit Information 21-2
DLP-A417 View the BLSR Squelch Table 21-5
DLP-A418 Install Public-Key Security Certificate 21-6
DLP-A421 Provision G-Series Flow Control Watermarks 21-7
DLP-A422 Verify BLSR Extension Byte Mapping 21-8
DLP-A428 Install Fiber-Optic Cables in a 1+1 Configuration 21-8
DLP-A430 View Spanning Tree Information 21-9
DLP-A431 Change the JRE Version 21-10
DLP-A433 Enable Node Security Mode 21-11
DLP-A434 Lock Node Security 21-12
DLP-A435 Modify Backplane Port IP Settings 21-13
DLP-A436 Disable Node Security Mode 21-14
DLP-A437 Change a VCAT Member Service State 21-15
DLP-A438 Change General Port Settings for the FC_MR-4 Card 21-16