Cisco ONS 15454 Series - Page 41

Tasks
xli
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
DLP-A330 Preprovision a Slot 20-20
DLP-A332 Change Tunnel Type 20-20
DLP-A333 Delete Circuits 20-21
DLP-A334 Delete Overhead Circuits 20-22
DLP-A335 Delete VLANs 20-23
DLP-A336 Repair an IP Tunnel 20-23
DLP-A337 Run the CTC Installation Wizard for Windows 20-24
DLP-A338 Run the CTC Installation Wizard for UNIX 20-27
DLP-A339 Delete a Node from the Current Session or Login Group 20-30
DLP-A340 View Port Status on the LCD 20-31
DLP-A341 Create an IP-Encapsulated Tunnel 20-32
DLP-A347 Refresh E-Series and G-Series Ethernet PM Counts 20-33
DLP-A348 Monitor PM Counts for a Selected Signal 20-34
DLP-A349 Clear Selected PM Counts 20-35
DLP-A350 View FC_MR-4 Statistics PM Parameters 20-36
DLP-A351 View FC_MR-4 Utilization PM Parameters 20-37
DLP-A352 View FC_MR-4 History PM Parameters 20-38
DLP-A353 Refresh FC_MR-4 PM Counts at a Different Time Interval 20-39
DLP-A356 TCC2/TCC2P Card Active/Standby Switch Test 20-40
DLP-A357 Create FC_MR-4 RMON Alarm Thresholds 20-41
DLP-A358 Delete FC_MR-4 RMON Alarm Thresholds 20-45
DLP-A359 Delete a Line DCC Termination 20-45
DLP-A362 Create a Four-Fiber BLSR Using the BLSR Wizard 20-46
DLP-A363 Create a Four-Fiber BLSR Manually 20-48
DLP-A364 Reset the TCC2/TCC2P Card Using CTC 20-49
DLP-A365 Initiate an Optical Protection Switch 20-50
DLP-A366 Initiate an Electrical Protection Switch 20-50
DLP-A367 Create a Provisionable Patchcord 20-51
DLP-A368 Delete a Provisionable Patchcord 20-52
DLP-A369 Provision an OC-N Circuit Route 20-53
DLP-A371 Remove Pass-through Connections 20-55
DLP-A372 Delete a Node from a Specified Login Node Group 20-56
DLP-A373 Install a MiniBNC EIA 20-57
DLP-A374 Change a Section DCC Termination 20-60
DLP-A375 Change a Line DCC Termination 20-60