Cisco ONS 15454 Series - Page 40

Tasks
xl
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
DLP-A265 Change the Login Legal Disclaimer 19-50
DLP-A266 Change IP Settings 19-51
DLP-A268 Apply a Custom Network View Background Map 19-52
DLP-A269 Enable Dialog Box Do-Not-Display Option 19-53
DLP-A271 Change Security Policy on a Single Node 19-53
DLP-A272 Change Security Policy on Multiple Nodes 19-55
DLP-A273 Modify SNMP Trap Destinations 19-56
DLP-A293 Perform a Manual Span Upgrade on a Two-Fiber BLSR 19-57
DLP-A294 Perform a Manual Span Upgrade on a Four-Fiber BLSR 19-58
DLP-A295 Perform a Manual Span Upgrade on a Path Protection 19-60
DLP-A296 Perform a Manual Span Upgrade on a 1+1 Protection Group 19-61
DLP-A297 Perform a Manual Span Upgrade on an Unprotected Span 19-62
DLP-A298 Check the Network for Alarms and Conditions 19-63
DLP-A299 Initiate a BLSR Span Lock Out 19-63
DLP-A300 Clear a BLSR Span Lock Out 20-1
DLP-A301 Initiate a BLSR Manual Ring Switch 20-2
DLP-A303 Initiate a BLSR Force Ring Switch 20-3
DLP-A309 View the Ethernet MAC Address Table 20-4
DLP-A310 View Ethernet Trunk Utilization 20-5
DLP-A311 Provision a Half Circuit Source and Destination on a BLSR or 1+1 20-5
DLP-A312 Provision a Half Circuit Source and Destination on a Path Protection 20-6
DLP-A313 Create a DCC Tunnel 20-7
DLP-A314 Assign a Name to a Port 20-8
DLP-A315 Log Out a User on a Single Node 20-9
DLP-A316 Log Out a User on Multiple Nodes 20-9
DLP-A320 View ML-Series Ether Ports PM Parameters 20-10
DLP-A321 View ML-Series POS Ports PM Parameters 20-11
DLP-A322 Manual or Force Switch the Node Timing Reference 20-13
DLP-A323 Clear a Manual or Force Switch on a Node Timing Reference 20-13
DLP-A324 Provision a VCAT Circuit Source and Destination 20-14
DLP-A325 Provision a VCAT Circuit Route 20-15
DLP-A326 Change a BLSR Node ID 20-16
DLP-A327 Configure the CTC Alerts Dialog Box for Automatic Popup 20-16
DLP-A328 Create a Two-Fiber BLSR Using the BLSR Wizard 20-17
DLP-A329 Create a Two-Fiber BLSR Manually 20-18