Cisco ONS 15454 Series - Page 39

Tasks
xxxix
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
DLP-A210 Change AIC-I Card Orderwire Settings 19-8
DLP-A212 Create a User Data Channel Circuit 19-8
DLP-A214 Change the Service State for a Port 19-9
DLP-A217 BLSR Exercise Ring Test 19-10
DLP-A218 Provision Path Protection Selectors 19-12
DLP-A219 Provision a VT Tunnel Route 19-13
DLP-A220 Provision E-Series Ethernet Ports 19-13
DLP-A221 Provision E-Series Ethernet Ports for VLAN Membership 19-14
DLP-A222 Provision G-Series Ethernet Ports 19-16
DLP-A225 Enable Alarm Filtering 19-17
DLP-A227 Disable Alarm Filtering 19-17
DLP-A229 View Circuits on a Span 19-18
DLP-A230 Change a Circuit Service State 19-19
DLP-A231 Edit a Circuit Name 19-20
DLP-A232 Change Active and Standby Span Color 19-21
DLP-A233 Edit Path Protection Circuit Path Selectors 19-22
DLP-A241 Clear a BLSR Manual Ring Switch 19-23
DLP-A242 Create a BLSR on a Single Node 19-23
DLP-A244 Use the Reinitialization Tool to Clear the Database and Upload Software (Windows) 19-25
DLP-A245 Use the Reinitialization Tool to Clear the Database and Upload Software (UNIX) 19-27
DLP-A246 Provision E-Series Ethernet Card Mode 19-29
DLP-A247 Change an OC-N Card 19-29
DLP-A249 Provision IP Settings 19-30
DLP-A250 Set Up or Change Open Shortest Path First Protocol 19-34
DLP-A251 Set Up or Change Routing Information Protocol 19-36
DLP-A255 Cross-Connect Card Side Switch Test 19-37
DLP-A256 View Ethernet Statistics PM Parameters 19-38
DLP-A257 View Ethernet Utilization PM Parameters 19-39
DLP-A258 View Ethernet History PM Parameters 19-41
DLP-A259 Refresh Ethernet PM Counts at a Different Time Interval 19-42
DLP-A260 Set Auto-Refresh Interval for Displayed PM Counts 19-43
DLP-A261 Refresh PM Counts for a Different Port 19-43
DLP-A262 Filter the Display of Circuits 19-44
DLP-A263 Edit Path Protection Dual-Ring Interconnect Circuit Hold-Off Timer 19-45
DLP-A264 Provision a J1 Path Trace on Circuit Source and Destination Ports 19-46