xlv
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
About this Guide
Note The terms “Unidirectional Path Switched Ring” and “UPSR” may appear in Cisco literature. These terms
do not refer to using Cisco ONS 15xxx products in a unidirectional path switched ring configuration.
Rather, these terms, as well as “Path Protected Mesh Network” and “PPMN,” refer generally to Cisco’s
path protection feature, which may be used in any topological network configuration. Cisco does not
recommend using its path protection feature in any particular topological network configuration.
This section explains the objectives, intended audience, and organization of this publication and
describes the conventions that convey instructions and other information.
This section provides the following information:
• Document Objectives
• Audience
• Document Organization
• Related Documentation
• Document Conventions
• Obtaining Optical Networking Information
• Obtaining Documentation, Obtaining Support, and Security Guidelines
Revision History
Document Objectives
This guide provides procedures for installation, turn up, provisioning, and acceptance of ONS 15454
nodes and ONS 15454 networks.
Date Notes
03/27/2007 Revision History Table added for the first time.
09/17/2007 Added a note after steps in the section “DLP-A255 Cross-Connect Card Side
Switch Test” in the “DLPs A200 to A299” chapter.
To Next Page
Loading...
Need help?
General
