A-7
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
Appendix A CTC Information and Shortcuts
Manage the CTC Window
Tools Circuits — Displays the following options:
• Repair Circuits—Repairs incomplete circuits following replacement of the
ONS 15454 alarm interface panel (AIP). Refer to the Cisco ONS 15454
Troubleshooting Guide for more information.
• Reconfigure Circuits—Allows you to reconfigure circuits. See the
“NTP-A298 Reconfigure Circuits” procedure on page 9-9 for more
information.
• Set Path Selector Attributes—Allows you to edit path protection circuit path
selector attributes. See the “DLP-A233 Edit Path Protection Circuit Path
Selectors” task on page 19-22.
• Set Circuit State—Allows you to change a circuit state. See the “DLP-A230
Change a Circuit Service State” task on page 19-19.
• Roll Circuit—Allows you to reroute live traffic without interrupting service.
This feature requires a Cisco ONS 15600 on your network. Refer to the
Cisco ONS 15600 Procedure Guide.
• Delete Rolls —This feature requires an ONS 15600 on your network. Refer
to the Cisco ONS 15600 Procedure Guide.
Overhead Circuits — Displays the Repair IP Tunnels option, which fixes circuits that are in the
INCOMPLETE state as a result of node IP address changes. See the “DLP-A336
Repair an IP Tunnel” task on page 20-23.
Tools
(cont.)
Topology Upgrade — Displays the following options:
• Convert UPSR to BLSR—Converts a path protection to a bidirectional line
switch ring (BLSR). See the “NTP-A267 Convert a Path Protection to a
Two-Fiber BLSR Automatically” procedure on page 13-13.
• Convert Unprotected to UPSR—Converts a point-to-point or linear
add/drop multiplexer (ADM) to path protection. See the “NTP-A299
Convert a Point-to-Point or Linear ADM to a Path Protection
Automatically” procedure on page 13-11.
Manage VLANs — Displays a list of VLANs that have been created and allows you to delete
VLANS. See the “DLP-A335 Delete VLANs” task on page 20-23.
Open TL1
Connection
Displays the TL1 session dialog box so you can create a TL1 session to a
specific node. Refer to the Cisco ONS 15454 and Cisco ONS 15327 TL1
Command Guide.
Open IOS
Connection
Displays the Cisco IOS command line interface dialog box if a Cisco IOS
capable card (ML1000-2 or ML100T-12) is installed in the node. Refer to the
Refer to the Ethernet Card Software Feature and Configuration Guide.
Help Contents and Index — Displays the online help window.
User Manuals — Displays the Cisco ONS 15454 documentation.
About CTC — Displays the software version and the nodes in the CTC session.
Table A-3 CTC Menu and Toolbar Options (continued)
Menu Menu Option Toolbar Description
To Next Page
Loading...
