Siemens SINAMICS G150 - Page 1089

SINAMICS G130/G150 List Manual (LH2), 04/2014, A5E03263479A
1089
3 Function diagrams
3.5 PROFIdrive
Fig. 3-51 2495 – CU_STW1 control word 1, Control Unit interconnection
- 2495 -
Function diagram
87654321
fp_2495_54_eng.vsd
DO: CU_G, CU_S
S120/S150/G130/G150
27.06.13 V04.07.00
PROFIdrive - CU_STW1 control word 1 Control Unit interconnection
Signal targets for CU_STW1
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
p0890.0 = r2090.2
-
-
-
p2103[0] = r2090.7
p3104 = r2090.1
Reserved
1. Acknowledge faults
Control via PLC
Master sign-of-life bit 0
Reserved
Reserved
Reserved
ESR-Trigger
RTC real time synchronization PING
Reserved
Reserved
Master sign-of-life bit 1
Master sign-of-life bit 2
Master sign-of-life bit 3
CU_STW1.1
CU_STW1.2
CU_STW1.3
CU_STW1.4
CU_STW1.5
CU_STW1.6
CU_STW1.8
CU_STW1.9
CU_STW1.11
CU_STW1.12
CU_STW1.13
CU_STW1.14
CU_STW1.15
CU_STW1.7
CU_STW1.10
---Central measuring probe, synchronizing signal sourceCU_STW1.0
Inverted
[Function diagram]
signal target
[Function diagram]
internal control word
Interconnection
parameters
MeaningSignal
-
-
-
-
-
-
- -
p0681[0] = r2090.0
p3116 = r2090.10
Reserved
p2045 =r2050[0]
-
<1> Used in telegrams 390 to 394.
<2> Only available when the function module "extended setpoint channel" is active (r0108.9 = 1).
<1>
PROFIdrive sampling time
<2>