Xerox Phaser 7100

Error Troubleshooting
Phaser 7100 Service Manual Xerox Internal Use Only2-72
116-312 HDD Encrypt Key Fail. During start up, an irregularity was detected in the
Encryption Key
2-321
116-313 HDD Encrypt Setup Fail. During start up, an encryption setting error was
detected.
2-321
116-314 Ethernet Address Fail 2-322
116-315 ESS RAM DIMM #1 W/R Check Fail 2-323
116-317 ESS ROM DIMM #1 Check Fail 2-324
116-321 SysCon Error 2-325
116-322 WebDAV-related Fatal Error 2-325
116-323 ESS NVRAM W/R Check Fail (NV-RAM parts failure) 2-326
116-324 System Detected an Exception Error 2-327
116-325 ESS Fan Fail 2-328
116-328 CPU Built-in Level 2 Cache Failure 2-329
116-330 HDD File System Fail 2-330
116-331 Log Management Information Incorrect The detection area is the NVM log
management information area, the same as for NVM Fail.
2-331
116-332 ESS On Board ROM Error 2-332
116-334 ESS NVRAM Data Compare Fail 2-333
116-336 Redirector Fail. HDD failure detected in the Redirector. 2-334
116-337 SNTP-related Fatal Error 2-334
116-338 JBA-related Fatal Error 2-335
116-340 Memory Not Enough. The Page Memory, Entry Buffer and Work Area are
insufficient. Malloc error, etc. The task cannot start up.
2-335
116-341 ROM DIMM Version Mismatch. The versions of several installed ROM
DIMM are incorrect.
2-336
116-342 SESAMi Manager Fatal Error 2-336
116-343 Main PWBA IC Fail 2-337
116-348 Various fatal errors detected by the redirector. 2-338
116-349 An error occurred when calling the Pflite function using the SIF. 2-338
116-351 An EtherTalk-related fatal error. 2-338
116-353 HDD Physical Fail 2-339
Error Message and Chain Link Code Display (Continued)
Chain Link Control Panel Message Go to Page