Cisco ONS 15454 Series User Manual

Contents
xi
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
DLP- A34 Create an Optimized 1+1 Protection Group 17-40
DLP- A35 Modify an Optimized 1+1 Protection Group 17-41
DLP- A36 Install the TCC2/TCC2P Cards 17-42
DLP- A37 Install the XCVT or XC10G Cards 17-45
DLP- A38 Install the Alarm Interface Controller or Alarm Interface Controller–International
Card
17-47
DLP- A39 Install Ethernet Cards 17-48
DLP- A43 Install Fiber-Optic Cables for Path Protection Configurations 17-49
DLP- A44 Install Fiber-Optic Cables for BLSR Configurations 17-52
DLP- A45 Install the Fiber Boot 17-54
DLP- A50 Set Up a Windows PC for Craft Connection to an ONS 15454 on the Same Subnet Using
Static IP Addresses
17-56
DLP- A51 Set Up a Windows PC for Craft Connection to an ONS 15454 Using Dynamic Host
Configuration Protocol
17-58
DLP- A52 Set Up a Windows PC for Craft Connection to an ONS 15454 Using Automatic Host
Detection
17-61
DLP- A53 Set Up a Solaris Workstation for a Craft Connection to an ONS 15454 17-63
DLP- A56 Disable Proxy Service Using Internet Explorer (Windows) 17-65
DLP- A57 Disable Proxy Service Using Netscape (Windows and UNIX) 17-66
DLP- A60 Log into CTC 17-66
DLP- A61 Create Login Node Groups 17-69
DLP- A62 Add a Node to the Current Session or Login Group 17-70
DLP- A64 Set the IP Address, Default Router, and Network Mask Using the LCD 17-71
DLP- A65 Create a Static Route 17-73
DLP- A67 Provision the IIOP Listener Port on the ONS 15454 17-74
DLP- A68 Provision the IIOP Listener Port on the CTC Computer 17-74
DLP- A69 Set Up External or Line Timing 17-75
DLP- A70 Set Up Internal Timing 17-77
DLP- A71 Create a 1:1 Protection Group 17-78
DLP- A72 Create a 1:N Protection Group 17-80
DLP- A73 Create a 1+1 Protection Group 17-81
DLP- A74 Create a New User on a Single Node 17-82
DLP- A75 Create a New User on Multiple Nodes 17-83
DLP- A83 Provision Orderwire 17-84
DLP- A88 Optical 1+1 Protection Test 17-85
DLP- A89 Remap the K3 Byte 17-87
DLP- A91 BLSR Switch Test 17-87
DLP- A92 Four-Fiber BLSR Exercise Span Test 17-91
DLP- A93 Four-Fiber BLSR Span Switching Test 17-93
DLP- A94 Path Protection Switching Test 17-95
DLP- A95 Provision a DS-1 Circuit Source and Destination 17-96

Cisco ONS 15454 Series Specifications

General

Supported Interfaces	Ethernet
Management	Cisco Transport Controller (CTC), TL1, SNMP
Power Supply	-48 VDC or AC (depending on power supply module)
Operating Temperature	0 to 50°C (32 to 122°F) - varies by module
Storage Temperature	-40°C to 70°C (-40 to 158°F)
Relative Humidity	5 to 95%, noncondensing
Supported Protocols	SONET/SDH, Ethernet, OTN
Platform Type	Multi-service transport platform