Cisco ONS 15454 Series User Manual

Contents
xiii
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
DLP- A168 Change Line and Threshold Settings for the DS3XM-6 Card 18-41
DLP- A169 Change Line and Threshold Settings for the EC1-12 Card 18-45
DLP- A170 Change Line Transmission Settings for OC-N Cards 18-49
DLP- A171 Change Threshold Settings for OC-N Cards 18-51
DLP- A172 Change an Optical Port to SDH 18-53
DLP- A173 Change External Alarms Using the AIC Card 18-54
DLP- A174 Change External Controls Using the AIC Card 18-54
DLP- A175 Change Orderwire Settings Using the AIC Card 18-55
DLP- A176 Convert DS1-14 Cards From 1:1 to 1:N Protection 18-56
DLP- A177 Convert DS3-12 Cards From 1:1 to 1:N Protection 18-57
DLP- A178 Convert DS3-12E Cards From 1:1 to 1:N Protection 18-59
DLP- A189 Verify that a 1+1 Working Slot is Active 18-60
DLP- A190 Install a UBIC-V EIA 18-61
DLP- A191 Delete a Card 18-65
DLP- A194 Clear a BLSR Force Ring Switch 18-66
DLP- A195 Verify Timing in a Reduced Ring 18-67
DLP- A196 Delete a BLSR from a Single Node 18-68
DLP- A197 Initiate a Path Protection Force Switch 18-68
DLP- A198 Clear a Path Protection Force Switch 18-70
CHAPTER 19 DLPs A200 to A299 19-1
DLP- A201 Apply a Lock On 19-1
DLP- A202 Apply a Lock Out 19-2
DLP- A203 Clear a Lock On or Lock Out 19-3
DLP- A204 Scope and Clean Fiber Connectors and Adapters with Alcohol and Dry Wipes 19-3
DLP- A205 Clean Fiber Connectors with CLETOP 19-4
DLP- A206 Clean the Fiber Adapters 19-5
DLP- A207 Install Fiber-Optic Cables on the LGX Interface 19-5
DLP- A208 Change External Alarms Using the AIC-I Card 19-6
DLP- A209 Change External Controls Using the AIC-I Card 19-7
DLP- A210 Change AIC-I Card Orderwire Settings 19-8
DLP- A212 Create a User Data Channel Circuit 19-8
DLP- A214 Change the Service State for a Port 19-9
DLP- A217 BLSR Exercise Ring Test 19-10
DLP- A218 Provision Path Protection Selectors 19-12
DLP- A219 Provision a VT Tunnel Route 19-13
DLP- A220 Provision E-Series Ethernet Ports 19-13
DLP- A221 Provision E-Series Ethernet Ports for VLAN Membership 19-14
DLP- A222 Provision G-Series Ethernet Ports 19-16
DLP- A225 Enable Alarm Filtering 19-17

Cisco ONS 15454 Series Specifications

General

Supported Interfaces	Ethernet
Management	Cisco Transport Controller (CTC), TL1, SNMP
Power Supply	-48 VDC or AC (depending on power supply module)
Operating Temperature	0 to 50°C (32 to 122°F) - varies by module
Storage Temperature	-40°C to 70°C (-40 to 158°F)
Relative Humidity	5 to 95%, noncondensing
Supported Protocols	SONET/SDH, Ethernet, OTN
Platform Type	Multi-service transport platform