Cisco ONS 15454 Series User Manual

Contents
xiv
Cisco ONS 15454 Procedure Guide, R5.0
December 2004
DLP- A227 Disable Alarm Filtering 19-17
DLP- A229 View Circuits on a Span 19-18
DLP- A230 Change a Circuit Service State 19-19
DLP- A231 Edit a Circuit Name 19-20
DLP- A232 Change Active and Standby Span Color 19-21
DLP- A233 Edit Path Protection Circuit Path Selectors 19-22
DLP- A241 Clear a BLSR Manual Ring Switch 19-23
DLP- A242 Create a BLSR on a Single Node 19-23
DLP- A244 Use the Reinitialization Tool to Clear the Database and Upload Software
(Windows)
19-25
DLP- A245 Use the Reinitialization Tool to Clear the Database and Upload Software (UNIX) 19-27
DLP- A246 Provision E-Series Ethernet Card Mode 19-29
DLP- A247 Change an OC-N Card 19-29
DLP- A249 Provision IP Settings 19-30
DLP- A250 Set Up or Change Open Shortest Path First Protocol 19-34
DLP- A251 Set Up or Change Routing Information Protocol 19-36
DLP- A255 Cross-Connect Card Side Switch Test 19-37
DLP- A256 View Ethernet Statistics PM Parameters 19-38
DLP- A257 View Ethernet Utilization PM Parameters 19-39
DLP- A258 View Ethernet History PM Parameters 19-41
DLP- A259 Refresh Ethernet PM Counts at a Different Time Interval 19-42
DLP- A260 Set Auto-Refresh Interval for Displayed PM Counts 19-43
DLP- A261 Refresh PM Counts for a Different Port 19-43
DLP- A262 Filter the Display of Circuits 19-44
DLP- A263 Edit Path Protection Dual-Ring Interconnect Circuit Hold-Off Timer 19-45
DLP- A264 Provision a J1 Path Trace on Circuit Source and Destination Ports 19-46
DLP- A265 Change the Login Legal Disclaimer 19-50
DLP- A266 Change IP Settings 19-51
DLP- A268 Apply a Custom Network View Background Map 19-52
DLP- A269 Enable Dialog Box Do-Not-Display Option 19-53
DLP- A271 Change Security Policy on a Single Node 19-53
DLP- A272 Change Security Policy on Multiple Nodes 19-55
DLP- A273 Modify SNMP Trap Destinations 19-56
DLP- A293 Perform a Manual Span Upgrade on a Two-Fiber BLSR 19-57
DLP- A294 Perform a Manual Span Upgrade on a Four-Fiber BLSR 19-58
DLP- A295 Perform a Manual Span Upgrade on a Path Protection 19-60
DLP- A296 Perform a Manual Span Upgrade on a 1+1 Protection Group 19-61
DLP- A297 Perform a Manual Span Upgrade on an Unprotected Span 19-62
DLP- A298 Check the Network for Alarms and Conditions 19-63
DLP- A299 Initiate a BLSR Span Lock Out 19-63

Cisco ONS 15454 Series Specifications

General

Supported Interfaces	Ethernet
Management	Cisco Transport Controller (CTC), TL1, SNMP
Power Supply	-48 VDC or AC (depending on power supply module)
Operating Temperature	0 to 50°C (32 to 122°F) - varies by module
Storage Temperature	-40°C to 70°C (-40 to 158°F)
Relative Humidity	5 to 95%, noncondensing
Supported Protocols	SONET/SDH, Ethernet, OTN
Platform Type	Multi-service transport platform